Club Homepage Forums Classified Ads Buy & Sell - Everything But Airplanes Instrument Panel Overlay

I am looking for a left side instrument panel overlay for my 1969 Cessna 150J. I was told that there is a member of the club who can make one for me. Can anyone point me in the right direction?

Today 8/28/2022 I finished refurbishing and repairing the overlay. In fact, I completed both the left and the right. As a result, I no longer need another one, so posters can disregard my earlier post looking for an overlay. Thanks to those that responded. I am attaching a photo of my finished product.

Would one from a 77M model work?

Hey Steven, Thanks for your response. I don't know. Do you have a picture that you could send?. My email is raysteelman64@gmail.com.

Ray.
For the left side You may consider removing the old plastic overlay and clean prime and paint the underlying panel. It turns out pretty nice.
Not as good as a custom made panel but a lot less expensive.
I did have a aluminum overlay made for the right side due to the gauge design. Pic’s below.

Hey Joe, Thanks for the response. That is exactly what I did today. I just put on the last coat of paint a few minutes ago. I still am open to buying another one if I find one. I hope that mine turn out to be as nice as yours....
Thanks again, Ray

Hi
There are a couple on eaby..
search cessna 150 panel.
her is one but there are plastic overlays also.

https://www.ebay.com/itm/225120015781?hash=item346a32d5a5:g:JbgAAOSw6I5i-ph1&amdata=enc%3AAQAHAAAAoDbXunFDSpaEir4ahE046chA0MVcFls5PhLBANxucOzjHbChbpoHLpVXCrrQbsc9jNgHs1RkhDE6YLTeAFNNUecSbZlxT1TobDjOdWsIQBffTiCt20sUtVR1SgUakV7LnQBGUupo0XwCZ6vdAmIV%2F8jmCZhVAtirbX%2BOupAXWUs0ZL4nSU9MDZrIiV51uJrwJLzvoqi%2BZ9%2BqkjmTF4HGm2I%3D%7Ctkp%3ABk9SR_CWp-XXYA

Ray, I am pretty sure I have one from a 73 L. I will look at the hanger tomorrow an let ya know. Mark

Thanks Michael. I have looked at them. One of them may work. Thanks again. Ray

Thanks Mark. Let me know if you find it. I doctored up my old one and painted it yesterday, but I am still open to replacing it. Thanks again, Ray

Thanks Michael. I have looked at them. One of them may work. Thanks again. Ray

Ray, I looked in the hanger and the only one I have was from a 150/150 upgrade. It has extra holes for the vac gauge and a hole for a fuel pressure gauge. Not sure if that works for your application. I added a picture so you can see it.
Mark

Hey Mark, Thanks for the effort, but that one will not work for me. I hope it was too much trouble for you. Thanks anyway.

Ray

Ray, Not at all. Good luck. Mark