Previous Thread
Next Thread
Print Thread
Page 1 of 3 1 2 3
WTB Audio Panel
#633791 01/17/22 05:42 PM
Joined: Jan 2022
Posts: 86
Likes: 12
V
Vince W Offline OP
Member
OP Offline
Member
V
Joined: Jan 2022
Posts: 86
Likes: 12
So this "New to Me" Aerobat is turning out to be the project I was expecting. The (most likely original) audio panel in it is basically... inop (old Radio Systems Technology panel). It came with a KMA 24 which I now know is also inop and not worth installing.

So I am looking for a used audio panel which is in decent shape to replace the ancient one which is in there now. What do I really "need"?

2 place intercom, 1 or 2 comms and at least 1 Nav. Marker Beacons would be great too.

Let me know if you have something gathering dust in your hangar!


Vince W.
aka Vinnie the Wig
A150L


[Linked Image from visitedstatesmap.com]
Re: WTB Audio Panel
Vince W #633805 01/17/22 10:39 PM
Joined: Aug 2006
Posts: 1,928
Likes: 279
Member/1500+posts
Offline
Member/1500+posts
Joined: Aug 2006
Posts: 1,928
Likes: 279
I'd check E-Bay. This kind of stuff is on there all the time.

A lot of folks have been re-doing their panels over the last few years and you might get lucky if someone has removed an audio panel that you could use.

Like most stuff on E-Bay, buyer beware.

Re: WTB Audio Panel
Vince W #633812 01/18/22 02:44 AM
Joined: Sep 2006
Posts: 8,766
Likes: 293
S
Member/7500+posts
Offline
Member/7500+posts
S
Joined: Sep 2006
Posts: 8,766
Likes: 293
If I were doing over, I would put in a two place intercom and two NAV/COMM radios. Most of the ILS's around here have decommissioned the marker beacons, so it might not be worth installing those. Our 150 has marker beacons, but they haven't flashed now in a couple of years. If you are going strictly VFR, one radio would be good enough, especially if it was one you could listen to two frequencies.

Even for IFR, I think something like the PAR200B (https://aopa.org/news-and-media/all-news/2021/june/pilot/pilot-products-ps-engineering-par200b) and maybe a Garmin 175 would work. If you went this route, you may also want to install an older NAV/COMM for ILS in emergencies.

Re: WTB Audio Panel
Vince W #633828 01/18/22 01:11 PM
Joined: Jun 2011
Posts: 17,984
Likes: 1735
Member/15,000 posts
Offline
Member/15,000 posts
Joined: Jun 2011
Posts: 17,984
Likes: 1735
I believe it is now FAA policy to no longer repair marker beacons when they fail. They have all but gone away in many parts of the USA.

That being the case and if all you needed was Intercom and listen to the COMM radio - newer radios come with the Intercom built in. Or if you want to keep older radios going - there is always something like a SIGTRONICS Intercom.


Graeme J W Smith
Re: WTB Audio Panel
Vince W #633831 01/18/22 02:37 PM
Joined: Jan 2010
Posts: 2,316
Likes: 53
Member/1500+posts
Offline
Member/1500+posts
Joined: Jan 2010
Posts: 2,316
Likes: 53
I have a used PS Engineering PMA6000M that you can have if you don't find something else you like better. It is a mono audio panel with marker beacon. Just make an offer. I replaced it a year or so ago with a PMA7000 that was a slide-in replacement and has Bluetooth.

E-Bay has one listed for $700, but just make an offer for whatever you'd like to pay.

Attached Files
IMG_2546.jpeg (122.28 KB, 173 downloads)
PMA6000_PG.pdf (121.91 KB, 3 downloads)
PMA6000S_IM.pdf (672.43 KB, 2 downloads)

Henry
N2011X - 1965 C182H
Re: WTB Audio Panel
Vince W #633834 01/18/22 05:32 PM
Joined: Jan 2022
Posts: 86
Likes: 12
V
Vince W Offline OP
Member
OP Offline
Member
V
Joined: Jan 2022
Posts: 86
Likes: 12
Thanks Henry! Let me do a little research on that unit and I'll get right back to you. Might be a good fit for the time being!

I'm also going to look at that PAR200B. Like most things in life, it's more than I really want to spend right now... but all good points about the Marker Beacons going away.

That would give me 2 Comms with one being a Comm/NAV for now.

Ultimately, I have plans to add a Garmin 175 or like GPS, add another G5 and pull the Vacuum System. I think with that set up I'd be done.

Plus new brakes, engine overhaul, new paint... Well, I'm sure I'm not the only one in this position!

Last edited by Thomas Walters; 01/18/22 05:50 PM.

Vince W.
aka Vinnie the Wig
A150L


[Linked Image from visitedstatesmap.com]
Re: WTB Audio Panel
Vince W #633835 01/18/22 05:47 PM
Joined: Jan 2010
Posts: 2,316
Likes: 53
Member/1500+posts
Offline
Member/1500+posts
Joined: Jan 2010
Posts: 2,316
Likes: 53
OK. Hopefully the attached manuals have all the details you need.


Henry
N2011X - 1965 C182H
Re: WTB Audio Panel
Vince W #634034 01/22/22 04:41 PM
Joined: Jun 2006
Posts: 106
Likes: 8
G
Member/100+posts
Offline
Member/100+posts
G
Joined: Jun 2006
Posts: 106
Likes: 8
I have a Garmin GMA-340 Audio Panel if interested.
Gordon Cragg
(713)-502-7274

Re: WTB Audio Panel
Vince W #634036 01/22/22 04:48 PM
Joined: Jan 2010
Posts: 2,316
Likes: 53
Member/1500+posts
Offline
Member/1500+posts
Joined: Jan 2010
Posts: 2,316
Likes: 53
Thanks, Gordon, but I don't need an audio panel. I'm happy with what I have.

I can't seem to find my old panel. Maybe Vince can use the GMA-340.


Henry
N2011X - 1965 C182H
Re: WTB Audio Panel
Vince W #634063 01/23/22 08:39 AM
Joined: Jan 2022
Posts: 86
Likes: 12
V
Vince W Offline OP
Member
OP Offline
Member
V
Joined: Jan 2022
Posts: 86
Likes: 12
Copy that Henry. Thanks for looking.

Gordon, I might be interested in that audio panel… I’ll send you a PM.


Vince W.
aka Vinnie the Wig
A150L


[Linked Image from visitedstatesmap.com]
Page 1 of 3 1 2 3

Link Copied to Clipboard
Powered by UBB.threads™ PHP Forum Software 7.7.4