That would be great!....You could just trace it Flat on paper I think and just mark where the bend goes, the bolt hole,, and a few dimensions so I can make sure it stays to scale (during scanning/printing). And measure the metal thickness too, I think I can take if from there.
And if you can scan and send it by PM or post it, I would be much obliged!
Here are the templates I traced and some pictures of the brackets, with your mailing address if you need me to mail you the actual templates. (Also sending you a PM)
N8395M 1970 A150K The Carolina Swampfoxes founding member I've landed my Aerobat in the following states:
Awesome man...thanks so much. They are smaller than I expected...I’m on vacation this week, so this is on my list of projects...thanks for all your help!
Awesome man...thanks so much. They are smaller than I expected...I’m on vacation this week, so this is on my list of projects...thanks for all your help!